[. . . ] “F. . . . ” Identification of faults for service technician Indicators Add rinse aid Add regeneration salt Only add regeneration salt immediately before starting a wash programme. “Delayed start” button The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. The dishwasher will start at the set time. “Half load” button The half load cycle can be used for the upper and lower rack. [. . . ] Select the required programme then press the “Half Load” button. The “Half Load” function can be used with programmes marked with an *. Programme chart Programmes Loading instructions Detergent 2) A X X X X Consumption 3) Litres kWh Minutes B X X X Pre-Rinse Quickwash Bio 1) (*) Normal (*) Intensive 1) 2) cold 40°C 50°C 60°C 70°C Crockery to be washed later. Recommended programme for heavily soiled crockery, especially suitable for pans and saucepans. 3) 5. 0 13. 0 16. 0 16. 0 17. 0 0. 02 0. 70 1. 24 1. 35 1. 65 10 30 133 120 145 Reference programme for energy label in compliance with EN 50242 regulations; Refer to “User instructions”; The data relevant to programmes are values obtained in the laboratory in conformity with Standard EN 50242. In practical use there may be time variations or leaps depending on different loads, function options, water temperatures or hardness and different power supply voltages. Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool. com”. 5019 696 93215 (We reserve the right to make technical modifications) How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it). If using combined action dishwasher tabs, follow the user instructions!Electric indicator on control panel (if provided). How to fill the detergent dispenser A BC Check the rinse aid level Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. Select the desired programme. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry If crockery is not perfectly clean • Insufficient rinse aid. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Use suitable glasses. • not removable • Insufficient water softening, calcium deposits. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. [. . . ] not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). Press the START button for 2 seconds, until the START indicator lamp switches off. [. . . ]